Installing Shingle Starter Course
Since the starter shingles will be covered by the roof shingles, it doesn’t matter what color they are, (except in special situations — see below). To 3/4 in.) overhang beyond the rake fascia.
The starter course has two layers of shingles.
Installing shingle starter course. The starter board is just a very straight, horizontal board used to hold the first course in place and arrange the sequence of the shingles. The top of the starter course should be situated alongside the chalk line. Requires no special tools, hardware or training;
You can finish off by applying a bead of roofing sealant between the first course and the starter strip. The starter course serves to fill the gaps in the first exposed course of shingles. The first exposed course of shingles should be flush with or, slightly over hanging, the starter course.
To prepare the tabs and lay the. Place the glue strip at and all along the drip edge as well as the rake edges. Starter shingles are the initial shingle products installed on the roof, just before the first course of the finish shingles, which will comprise the visible parts of the roof.
Not only is this a waste of expensive shingles, but the time. Control line and nail them down, four nails per shingle. Keep the individual shingle tabs to use as finishing pieces.
Lay them flush against the starter strip and secure with four nails. Trim 5 (127 mm) and apply as shown (see figure 2). To prepare the tabs and lay the starter.
Installing the first course the starter strip is installed next, and usually lines up with the bottom of the wall, 2 inches from any masonry, depending on the project. Starter course • rip cut a 9” starter course from the top of a full panel. Install a starter course at the eaves of the roof, allowing a 4 cm (11/2 in.) overhang beyond the eaves fascia and a 128 mm to 192 mm (1/2 in.
Roofing contractors for years have relied on cutting 3 tab shingles down to make a starter course when installing an asphalt shingle roof. Simply apply a single course of starter shingle roll along a clean, dry and smooth eave line or rake edge, after removing the release sheet. Install the first course all the way across the roof.
Install the first course of wood shingles on top of the starter course. If a uniform straight edge is preferred, use a straight edge on the bottom of shingles. If required (heavy snow regions), overlay the starter course with two layers of shingles.
If you are making your own starter shingles, cut the tabs off for the starter course (bottom row) of shingles. Often, however, a starter course is made of cut shingles. • apply in dry weather at recommended temperatures of 40º f,.
The starter course should overhang the bottom of the wall or the facer of a roof by a minimum of 3/4 inch. Per shingle, a minimum of four nails are required. [figure 7] another method consists of installing the first course using shingles trimmed 5 from the base, then continuing the.
0 Response to "Installing Shingle Starter Course"
Post a Comment